Baby Groot Head Keychain — 31 mm Chibi Charm

All bark, carved in — the one that takes a wash best.

A chibi Baby Groot head keychain — one solid piece with the hanging loop modelled into the top, so

there is nothing to glue and nothing to assemble. The face and the whole crown of bark are cut into

the geometry rather than painted on, so they still read at keychain size and after a coat of paint.

The file is already at keychain scale: 26.2 × 32.3 × 31.1 mm, print it at 100 % and the loop comes

out right.

The photo is a real print of this exact file at 100 % — raw grey PLA, straight off the plate, no

filler and no paint.

Why you will like it

- One piece, no assembly — the loop is part of the print, and so is every strand of bark. Add a

split ring and it is done.

- The loop hole is 4.4 mm — measured in the file, at 100 %. A standard 20 × 1.2 mm split ring goes

straight through — no drilling, no rescaling, no fused loop. It is the tightest loop of the six, so

it is the one worth a glance in the first-layer preview.

- The easiest overhangs in the series — only 9.9 % of the surface sits past 45°, despite all that

bark. The strands run vertically, which is exactly what a printer wants.

- Watertight and slicer-safe — a single closed solid, zero open edges, 179 976 triangles. No repair

step, no manifold warnings.

- Built for a wash — 29.6 cm² of surface, nearly all of it grooved. Brush a dark brown over a woodcoloured PLA, wipe the high spots, and it stops looking printed.