Talaria Sting R - Handlebar Bar Ends / Plugs (OEM Mirror Delete)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Clean up your cockpit and protect your grips with these custom, low-profile bar ends for the Talaria Sting R.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 39
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Key Features:
Smart Hardware Reuse: Designed specifically to utilize the exact same mounting screws and internal expanding inserts from the original homologated mirror setup.
Crash Protection: Acts as a slider/buffer to absorb impact and prevent your throttle tube from getting crushed or jammed with dirt in a fall.
Clean Motocross Aesthetic: Gives your handlebars a finished, aggressive look without the bulk of factory mirrors.
Hardware Required (BOM):
Zero extra cost! This model is designed to perfectly fit the original screws and expanding metal inserts from the factory homologated mirrors. Just drop them into the printed part and tighten.
Recommended Print Settings:
Material: TPU / TPE (Flexible) or ASA / PC (Rigid).
Option 1 (Highly Recommended): Printing these in a hard flexible filament (like TPE 32D or 95A TPU) makes them virtually indestructible. They will absorb impacts during a crash without shattering.
Option 2: For a rigid, slider-style bar end, use ASA, Polycarbonate, or at least PETG. (Avoid PLA as it can shatter and leave sharp plastic edges if you drop the bike).
Wall/Perimeters: 5+ perimeters for maximum crush resistance against the mounting screw.
Infill: 50% to 100% (If printing in TPU, 100% solid infill is highly recommended for the best impact absorption).
Orientation: Print flat on the smooth outer face. This ensures the cleanest visible surface and provides the best structural orientation for the screw counterbore.
Supports: No supports required if printed flat on the outer face.