Dustboot for 80mm spindle and 4" suction hose
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Dustboot for 80mm spindle and 4" suction hose, don't adapter it down from 4", use a true 4" connector, get full flow.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 123
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
Had a small boot for my Onefinity cnc with 80mm spindle, but got a dust collector that uses 4" hose. Rather than neck it down from 4" to about 2", wanted a 4" straight through, to get the full suction.
So I drew this up, played with it a bit. May be some revisions down the road, who knows.
For brushes that fit in snugly i used Easy-Cut Strip Brush 7/32" wide x 3/16" backing. It comes in 1", 2" and 3" from McMaster-Carr.
Magnets to hold the foot onto the boot are 4.5mm x 4.5mm N50 magnets.
I print on a Sovol SV06 Plus ACE.
*For personal, non-commercial use. Commercial sale of this design or physical prints made from it is not permitted without permission from me.