S-Pen Cover for A1916 Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Hard cover replacement for the flimsy fabric S-Pen strap on the A1916 case.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 18
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A rigid S-Pen replacement cover designed for the A1916 tablet case from AliExpress. The factory fabric elastic loop doesn't feel secure enough for me; this print provides a solid, secure enclosure that prevents the stylus from damage or slipping out during transport.
Installation
Remove original strap: Carefully cut off the factory fabric strap flush against the case body with a craft knife or flush cutters.
Gluing: Apply a thin, even bead of cyanoacrylate (superglue) to the mounting surface of the printed part.
Cure: Press firmly into position from inside of the case. Maintain pressure for 30–60 seconds, then allow it to fully cure (ideally 1–2 hours) before inserting the S-Pen or attaching the case back to your tablet.
Print Settings
Material: PETG preferred. PLA is acceptable.
Perimeters / Walls: 2–3
Infill: 100%
Layer Height: 0.10 mm ideally, but anything up to 0.20 mm works.
Supports: None