Little Werewolf — Halloween Figure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A small werewolf with a mane, a ruff and a tail curled round behind it — and the lightest print in the set.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 27
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Standard Digital File License
A small werewolf with a mane, a ruff and a tail curled round behind it — and the lightest print in
the set.
At 60 % scale it is 38.2 × 60.0 × 48.8 mm and about 19 g of PLA, half the weight of the cauldron.
If you are printing the whole set, this is the one to start with.
The photos are a real print of this file at 60 % scale, orange PLA, unpainted.
What is measured, not guessed
- Watertight — zero open edges, zero non-manifold edges, one connected solid, 199 980 triangles.
- No supports. 14.7 % of the surface past 45°, and the largest flat ceiling anywhere on it is 0.10
cm², 5 mm across. The tail is the only thing that leaves the silhouette and it curls down to the
base rather than out into the air.
- Flat base 582 mm² at 60 %. Stands square, no brim.
- Arms fused to the body — deliberate. Separated limbs on a figure this size are how you get a
model that arrives in two pieces, and how a slicer gets an excuse to put supports in the armpit.