Little Werewolf — Halloween Figure

A small werewolf with a mane, a ruff and a tail curled round behind it — and the lightest print in

the set.

At 60 % scale it is 38.2 × 60.0 × 48.8 mm and about 19 g of PLA, half the weight of the cauldron.

If you are printing the whole set, this is the one to start with.

The photos are a real print of this file at 60 % scale, orange PLA, unpainted.

What is measured, not guessed

- Watertight — zero open edges, zero non-manifold edges, one connected solid, 199 980 triangles.

- No supports. 14.7 % of the surface past 45°, and the largest flat ceiling anywhere on it is 0.10

cm², 5 mm across. The tail is the only thing that leaves the silhouette and it curls down to the

base rather than out into the air.

- Flat base 582 mm² at 60 %. Stands square, no brim.

- Arms fused to the body — deliberate. Separated limbs on a figure this size are how you get a

model that arrives in two pieces, and how a slicer gets an excuse to put supports in the armpit.