Multiboard Mount for Radiomaster Zorro Transmitter | FPV Controller Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Keep your FPV workspace organized and your gear ready to fly.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 29
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Key Features:
Multiboard Compatible: Designed to snap seamlessly into the Multiboard hex grid system.
Tailored Fit: Perfectly matches the geometry of the Radiomaster Zorro for a secure hold.
Clean Organization: Gets your radio off the desk and turns it into a display piece in your workshop.
Hardware Required (BOM):
100% 3D Printed. No extra hardware or screws required. It mounts directly into the Multiboard grid (utilizing standard Multiboard snaps or push-fit mechanics based on your grid setup).
Recommended Print Settings:
Material: PLA or PETG. PLA is perfectly fine for indoor storage, but PETG offers a bit more flex, which is great for the mounting pegs/snaps snapping into the wall without breaking.
Wall/Perimeters: 3 to 4 perimeters. You need the mounting pegs on the back to have solid walls so they don't shear off under the weight of the controller.
Infill: 15–20% Gyroid or Cubic.
Orientation: Print it on its side (profile view). This is crucial! If you print it upright, the layer lines will run parallel to the mounting pegs on the back, making them prone to snapping off inside your Multiboard. Printing on the side ensures continuous extrusion through the pegs and the main body, giving it maximum shear strength.
Supports: Standard supports are likely needed for the overhanging lip that cradles the controller, and potentially for the mounting pegs depending on your exact side-orientation.