Vespa GTS Glovebox Hinge Repair

Vespa GTS / GTV Glovebox Hinge Fix – Broken Lower Hinge Repair

A cost-effective repair for the Piaggio Vespa GTS and GTV glovebox door where the lower hinge has snapped off. This is a common failure — and because Piaggio only sells the glovebox door as a complete assembly, a broken hinge usually means buying an expensive whole new door.

This part replaces the broken hinge and returns the original door to service for the cost of a few grams of filament and a steel pin.

Original design, modelled to match the factory hinge geometry.

✅ Features

• Repairs the common broken lower glovebox hinge on GTS / GTV models

• Saves replacing the entire glovebox door — a very expensive single part

• Steel pin reinforcement through the hinge boss for real-world strength

• Pre-configured .3mf included — correct print orientation and settings already dialled in

• STL, STEP and other formats included if you prefer to set it up yourself

• Original design

🖨 Recommended Print Settings

⚠ Print settings matter on this one. This is a small structural part that gets loaded every time the glovebox is opened, and it lives inside a legshield that gets hot in the sun. Don't cut the perimeters back, and don't print it in PLA — use ASA or ABS for the heat and impact resistance the job needs.

💡 Use the included .3mf file — import it into PrusaSlicer (or your slicer of choice) and the model arrives correctly oriented with most settings pre-filled. Orientation has been chosen to run the layer lines the right way for strength, which is why supports are needed. If you'd rather set it up yourself, the STL and STEP files are included too.

🔧 Assembly

1. Print using the included .3mf (ASA or ABS, supports on).

2. Remove supports carefully and clean up the mating faces and the hinge bore.

3. Press a 1.7 mm steel pin into the circular hinge pin — this is essential, the printed boss alone is not strong enough.

4. Trim the pin flush if needed.

5. Fit the repair part to the glovebox door and refit the door to the scooter (epoxy, screw or rivet as required).

🔩 What You'll Need

• 1 × steel pin, 1.7 mm diameter × 30 mm long

💡 Easiest source: take a 3.2 mm open (blind) pop rivet and cut the head off the mandrel. The remaining steel pin/nail is exactly the right diameter (1.7 mm) and length (30 mm) for this part — no measuring, no filing, and you probably already have a handful in the shed.

🛵 Compatibility

• Piaggio Vespa GTS — glovebox door, lower hinge

• Piaggio Vespa GTV — glovebox door, lower hinge

Saved a glovebox door from the bin? Post a make — always good to see another one back on the road.