Pegboard Organisers Collection (SKÅDIS Supported)

This project now supports IKEA SKÅDIS and 25x25 pegboards.

SKÅDIS required some small redesigns to some models to make it work with the larger hooks, but most of everything else remained the same.

Overview

This is my growing collection of pegboard holders that I have designed for my workshop pegboards. Each part is designed around the item(s) it holds, keeping tools and parts easy to find and access.

The holders are all designed for a pegboard with hole spacing (centre to centre) of 25mm x 25mm as seen in the image below (and now also SKÅDIS).

Holders Designed

• iFixit Mako

• Ruler

• Pinecil

• DJI Mini 3/4/5 drone

• DJI RC controller

• Breadboards

• Tweezers and picks

• Cable hooks

• Digital calipers

• Dupont Jumper wires

• Storage containers (small and large with labels)

• Wire spools (6 spools and 5 spools)

• Wire strippers

• Wire cutters

• Grease container

• Allen keys

• Glue stick (27mm and 32mm)

• Headphones

• Creality spanners

• Modular tape rolls holder

• Drill bits (19 sizes, from 1mm to 10mm with 0.5mm increment)

I'll continue adding new holders as I find more things in the workshop that need a home on a pegboard while also improving the existing holders.

Mounting

Each holder uses hooks on the back which are designed to tilt in and lock down, while keeping them easy to remove. Because of the shape of the rear hooks, supports are needed but the supports are minimal and easy to remove. Some models require additional supports, but most do not.

Update

I have added support for SKÅDIS and also redesigned multiple holders for simpler printing, improved durability and broader compatibility. The following models were tweaked or redesigned:

Pinecil Holder

The heat thread insert storage slots along the bottom are now tilted to make them easier to access. The tolerances for the heat thread insert holes has also been increased to make removal easier.

Glue Stick Holder

I greatly reduced the thickness of the holder from the original and also angled the glue stick to make removal easier.

Tape Holder

The original tape holder was designed specifically for my masking tape rolls which was too specific. I completely redesigned it to be modular and widely compatible with most of all tape rolls. The new design consists of a base which mounts to the pegboard and an arm that attaches to the base. The holder remains durable and the base can be reused for something like a hook.

Digital Caliper Holder

Moving away from a 3-part design, the new design is much simpler. Previously, there were two slide in parts that attached to the main body so the holder could be locked to the pegboard. It was larger than it needed to be and much more complex than it needed to be. The redesign keeps it simple while remaining functional.