1 / 3
Ruger Mark 3 Factory and Pac-lite RMR Optic Plate — zdjęcie 1
1 / 3

Ruger Mark 3 Factory and Pac-lite RMR Optic Plate

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This optic plate replaces the rear sight on the factory Ruger Mark 1,2,3 Barrel and Pac-Lite Barrel

Ocena
0 / 5
Polubienia
1
Pobrania
2
Wydruki
0
Wyświetlenia
100
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Standard Digital File License

These files are for replace the rear sight on the factory and tactical solutions paclite barrel on a ruger mark 1, 2, 3 with a RMR Optic plate. They were specifically designed for the Holosun 407/507 red dot, but should work with any rmr footprint. 

There are 2 optic plates included. 

The pac-lite optic plate: This version has 2 holes in it. When you remove the flat head screw from the pac-lite rear sight, there is a smaller hex head screw holding the sight to the barrel. I had to drill mine out, since mine wouldn't come loose. Then I re-tapped that hole with a m3 tap (just what I happened to have on hand). The larger front screw hole is a #6-48 thread. 

On the factory optic plate: Remove the set screw from the rear sight, then tap out the rear site. It's a dovetail design so it slides out the side. The optic plate slip slots into the rear half of the dovetail, and then is bolts to the barrel using a #6-48 screw. I used on the factory screws that came with my factory Picatinny rail for the top of the barrel. 

Print Settings:
I used PETG-CF for filament
.12 Layer Height
6 Perimeters
60% Infill
Gyroid Infill Pattern
Printed flat surface to the bed. 
No support needed.

Tagi