Ruger Mark 3 Factory and Pac-lite RMR Optic Plate
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This optic plate replaces the rear sight on the factory Ruger Mark 1,2,3 Barrel and Pac-Lite Barrel
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 2
- Makes
- 0
- Views
- 100
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Standard Digital File License
These files are for replace the rear sight on the factory and tactical solutions paclite barrel on a ruger mark 1, 2, 3 with a RMR Optic plate. They were specifically designed for the Holosun 407/507 red dot, but should work with any rmr footprint.
There are 2 optic plates included.
The pac-lite optic plate: This version has 2 holes in it. When you remove the flat head screw from the pac-lite rear sight, there is a smaller hex head screw holding the sight to the barrel. I had to drill mine out, since mine wouldn't come loose. Then I re-tapped that hole with a m3 tap (just what I happened to have on hand). The larger front screw hole is a #6-48 thread.
On the factory optic plate: Remove the set screw from the rear sight, then tap out the rear site. It's a dovetail design so it slides out the side. The optic plate slip slots into the rear half of the dovetail, and then is bolts to the barrel using a #6-48 screw. I used on the factory screws that came with my factory Picatinny rail for the top of the barrel.
Print Settings:
I used PETG-CF for filament
.12 Layer Height
6 Perimeters
60% Infill
Gyroid Infill Pattern
Printed flat surface to the bed.
No support needed.