Hotend Bracket for E3D Volcano and BLTouch (to suit Geeetech printers & Clones)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I've uploaded my latest hotend for those that use the printers with a 30mm spacing as used on the GeeeTech printers…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 190
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
I've uploaded my latest hotend for those that use the printers with a 30mm spacing as used on the GeeeTech printers and clones. As I use a Volcano Hotend with a 0.4mm nozzle, and ive decided to go back to a BLTouch for my bed leveling, and when adjusting your marlin firmware the mount has the BLTouch probe 30mm to the left of the nozzle. The screws used are M4 x 20mm and M4 Nuts, the BL Touch is held on with M3 x 12mm and M3 Nuts
And to make it easier for some I have uploaded a Gcode file with the parts already laid out to print in the center of the bed, in ABS. And with the correct print settings.
Have fun with the new hot end bracket
Print Settings
Printer:
Geeetech i3B Clone
Rafts:
Yes
Supports:
Yes
Resolution:
0.2mm
Infill:
30%
Notes:
Print in ABS for durability
I've also included a GCode file already set out to print that has the The bed temp set to 110C and the Hotend to 235C.That has been silced with Simplify 3D
Front End bracket
Raft: Yes
Support: Yes
Resolution: 0.2mm
Print speed: 1900mm/m
Infill: 30%
Back End Bracket
Raft: No
Support: Yes
Resolution: 0.2mm
Print speed: 1900mm/m
Infill: 30%
Category: 3D Printer Parts