Moroccan Lantern Collection for Govee S14 String Lights

A coordinated collection of four different Moroccan-style lantern shades for Govee S14 outdoor string lights, specifically the H702B/H702C integrated-plastic LED models.

FOUR STYLES

• Star Palace — eight-point medallions, symmetrical tracery and a star-pierced onion roof

• Moorish Quatrefoil — floral medallions, scalloped arches and four-point roof motifs

• Andalusian Diamond — nested diamonds, angular tracery and a geometric crown

• Marrakesh Sunburst — twelve-point medallions, radiating spokes and sunburst perforations

All four share the same 168 × 99.8 × 99.8 mm exterior envelope, two-piece clamshell installation, M3 hardware and interchangeable collars. Alternate A–B–C–D along the string or use any sequence.

INCLUDED FILES

• Eight lantern-shell STL files: Half A and Half B for each style

• Six socket-collar STL files: Small, Medium and Large, each in two halves

• Assembly and printing instructions

• Collection preview

• Editable source scripts

PRINT THE COLLAR TEST FIRST

Govee publishes the overall lamp dimensions but not the tapered socket size. Begin with the Medium 22 × 30 mm collar. Use Large 24 × 32 mm if too tight or Small 20 × 28 mm if loose before the screw is snug. Never force the collar or clamp the cable, hook, branch or plastic LED bulb.

COMPATIBILITY

Designed around the published Govee H702B/H702C envelope: 90.9 mm overall socket-and-bulb height and 46.0 mm maximum plastic bulb diameter. The STL meshes are structurally closed/manifold and fit a Creality K1C build volume. The socket collars have not yet been physically fitted to the Govee taper, so the collar test is mandatory before printing multiples.

PRINT SETTINGS

Use outdoor-rated PETG or ASA; do not use ordinary PLA outdoors. Suggested K1C settings: 0.4 mm nozzle, 0.20 mm layers, 4 walls, 5 top/bottom layers, 20–25% gyroid infill, no supports in the supplied split-face-down orientation, and an optional 5–8 mm brim.

HARDWARE PER LANTERN

• Five M3 × 20 mm stainless machine screws

• Five M3 stainless nuts

• Optional M3 washers

ASSEMBLY AND SAFETY

Disconnect power and work with the string cool and dry. Fit the selected collar around the tapered plastic socket, align its relief with the original hook/cable branch and tighten only enough to prevent sliding. Fit the two shell halves, loosely install the four shell screws, centre the bulb with at least 3 mm clearance and tighten evenly.

The printed lantern is decorative. It must not carry string tension or replace Govee’s support hardware or IP66 rating. Do not drill or glue the Govee housing. Keep the open bottom unobstructed for drainage, inspect regularly for cracking or trapped water, and remove during high wind or ice.

Govee and its product names are trademarks of their respective owner. This independent accessory is not affiliated with or endorsed by Govee.