1 / 3
Winnebago Revel shower drain odor plug (TPU sleeve + screw cap) — zdjęcie 1
1 / 3

Winnebago Revel shower drain odor plug (TPU sleeve + screw cap)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Two-part plug that stops grey-tank odor coming up the Winnebago Revel shower drain. TPU sleeve + rigid screw cap.

Ocena
0 / 5
Polubienia
1
Pobrania
12
Wydruki
0
Wyświetlenia
75
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Bathroom
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Stops grey-tank odor coming up the bathroom floor drain in a Winnebago Revel. Replaces the tape I had over mine.

Cap in to seal the drain, cap out to shower.

Parts

Sleeve (TPU): pushes into the stainless drain throat and stays there. Four ribs on the outside grip the throat and seal against it. A hex grate at the bottom catches hair. Threaded inside.

Cap (PETG or ASA): threads into the sleeve with a 3-start thread, about half a turn. Its conical seat presses into the soft sleeve, so the TPU is the gasket and there are no O-rings. Two arc slots in the top give your fingers a wall to push against when it's wet and soapy. A coin or screwdriver fits the slot if it sticks.

Fit

Sleeve is 45.4 mm across the ribs and 32.25 mm tall. Cap head is 43 mm. It fits the drain in my Revel. Measure your drain throat before printing.

Printing

Both files are already in print orientation. No supports.

Sleeve: TPU 95A or harder. 85A is too soft to hold the thread. Direct drive, 20-30 mm/s, 5+ perimeters, 100% infill. Prints grate-side down.

Cap: PETG or ASA. A TPU cap binds in TPU threads. The cap sits above the bed in the file, so let the slicer drop it to the plate.

Removing the sleeve

Thread the cap in fully and pull. The cap doubles as the puller.

Tagi