1 / 3
Winnebago Revel shower drain odor plug (TPU sleeve + screw cap) — image 1
1 / 3

Winnebago Revel shower drain odor plug (TPU sleeve + screw cap)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Two-part plug that stops grey-tank odor coming up the Winnebago Revel shower drain. TPU sleeve + rigid screw cap.

Rating
0 / 5
Likes
1
Downloads
12
Makes
0
Views
75
Reviews
0

Updated at source:

Model information

Category
Bathroom
License
Creative Commons — Attribution — Noncommercial — Share Alike

Stops grey-tank odor coming up the bathroom floor drain in a Winnebago Revel. Replaces the tape I had over mine.

Cap in to seal the drain, cap out to shower.

Parts

Sleeve (TPU): pushes into the stainless drain throat and stays there. Four ribs on the outside grip the throat and seal against it. A hex grate at the bottom catches hair. Threaded inside.

Cap (PETG or ASA): threads into the sleeve with a 3-start thread, about half a turn. Its conical seat presses into the soft sleeve, so the TPU is the gasket and there are no O-rings. Two arc slots in the top give your fingers a wall to push against when it's wet and soapy. A coin or screwdriver fits the slot if it sticks.

Fit

Sleeve is 45.4 mm across the ribs and 32.25 mm tall. Cap head is 43 mm. It fits the drain in my Revel. Measure your drain throat before printing.

Printing

Both files are already in print orientation. No supports.

Sleeve: TPU 95A or harder. 85A is too soft to hold the thread. Direct drive, 20-30 mm/s, 5+ perimeters, 100% infill. Prints grate-side down.

Cap: PETG or ASA. A TPU cap binds in TPU threads. The cap sits above the bed in the file, so let the slicer drop it to the plate.

Removing the sleeve

Thread the cap in fully and pull. The cap doubles as the puller.

Tags