1 / 3
165mm / 6.5 inch speaker adapter for kia picanto (2004-2007) — zdjęcie 1
1 / 3

165mm / 6.5 inch speaker adapter for kia picanto (2004-2007)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This adapter replaces the original speaker bracket in kia picanto cars released between 2004-2007.

Ocena
0 / 5
Polubienia
0
Pobrania
16
Wydruki
0
Wyświetlenia
62
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This adapter replaces the original speaker bracket that holds the 4 inch speakers in 2004-2007 kia picanto models.

Created to house JBL charge 1 gen 2 62F car speakers, but I believe the holes should be compatible with most aftermarket 165mm / 6.5 inch speakers. If not, feel free to remix. 

Since it's supposed to go inside of a car, it's best not to use PLA to print this, as it does not last long in a hot summer car. Instead use something more heat resistant like PETG or ABS.
See how I printed mine further below.

Assembly:

  1. put m5 nuts in the slots on the inside of the bracket

  2. place speaker in position, align with the correct holes

  3. use m5 screws (15-20mm long) to attach speaker to the adapter

  4. plug speaker into the car's wiring

  5. use the original bracket's 4 mounting screws to attach the assembly to the door.

    IMPORTANT: make sure the assembly is orientated correctly, the tallest part should face towards the back of the car, the shortest towards the front. Not doing this could result in damage to the speaker, the adapter and/or the car itself.

You can use a soft interfacing material wherever parts meet to reduce vibrations. i am not an audio/car guy, so I don't know if it will matter much but that's what all sources keep telling me. Just make sure said materials aren't flammable. Just in case.

My print settings:

  • Printer: bambu A1 Mini (barely fits on the build plate, best to use a generous brim to help prevent warping)

  • Material: Esun PETG black

  • Layer height: 0.28mm

  • Walls: 4

  • Detect thin walls: on

  • Infill: 15% Gyroid

  • Support: Only under the 4 mounting tabs.

Tagi