Olfa Knife and Blade Holder for Multiboard, Wider Version
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Olfa retractable utility knife and spare blade holder for Multiboard
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 14
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
Literally the same as the original model, except the knife slot is 2 mm wider. The knife handle is asymmetrical and the knob didn't fit correctly when the blade was fully retracted.
Note that the pushfits are loose. I'm not sure if this is from using a support interface material which made them too small or if something was slightly off from the STL conversion process. I found the original model also had this issue. To solve it, I just wrapped the pushfits with masking tape.
You will also need to print 2x snaps to make this work.
Print with a brim; parts of this have very little build plate contact and will warp.