Magnetic Vent Air Director - Low Profile
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is used redirect air from a ceiling vent outwards; easily magnetically attachable & CFD optimized for airflow.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 43
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bedroom
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Magnetic Ceiling Vent Air Director (Low Profile)
Redirects airflow outward across the room rather than straight down onto your bed or desk. Low-profile design with a smooth internal curve to minimize air restriction, backpressure, and noise.
Printing:
Material: PETG or ABS/ASA recommended (avoid PLA if your vent blows hot air in the winter, as it will sag/warp over time).
Layer Height: 0.20mm.
Walls/Perimeters: 3–4 walls for rigidity.
Infill: 15–20% (Gyroid or Grid).
Supports: None.
Orientation: Print flat with the mounting base directly on the build plate.
Hardware Needed:
4x Neodymium disc magnets 0.565"
Super glue
How to Install:
Insert Magnets: Press-fit the neodymium magnets into the recessed pockets on the base. Add a drop of CA glue if necessary.
Prep Surface: Wipe down the steel vent slats to remove dust.
Mount: Orient the opening away from your workspace or bed, then snap it directly onto the metal ceiling register. No screws or permanent modifications required.