Magnetic Vent Air Director - Low Profile
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is used redirect air from a ceiling vent outwards; easily magnetically attachable & CFD optimized for airflow.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 7
- Makes
- 0
- Views
- 44
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bedroom
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Magnetic Ceiling Vent Air Director (Low Profile)
Redirects airflow outward across the room rather than straight down onto your bed or desk. Low-profile design with a smooth internal curve to minimize air restriction, backpressure, and noise.
Printing:
Material: PETG or ABS/ASA recommended (avoid PLA if your vent blows hot air in the winter, as it will sag/warp over time).
Layer Height: 0.20mm.
Walls/Perimeters: 3–4 walls for rigidity.
Infill: 15–20% (Gyroid or Grid).
Supports: None.
Orientation: Print flat with the mounting base directly on the build plate.
Hardware Needed:
4x Neodymium disc magnets 0.565"
Super glue
How to Install:
Insert Magnets: Press-fit the neodymium magnets into the recessed pockets on the base. Add a drop of CA glue if necessary.
Prep Surface: Wipe down the steel vent slats to remove dust.
Mount: Orient the opening away from your workspace or bed, then snap it directly onto the metal ceiling register. No screws or permanent modifications required.