1 / 1
Jig for meshtastic EU_868 J-pole — zdjęcie 1

Jig for meshtastic EU_868 J-pole

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This model is made for easy and beginner-friendly way to make 869.525mhz tuned j-pole antenna. just bend, fit and cut.

Ocena
0 / 5
Polubienia
5
Pobrania
6
Wydruki
0
Wyświetlenia
79
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial
  • Tuned 869.525

  • just bend, fit, cut flush and solder.

  • made to be as beginner-friendly as possible.

  • PLA or PETG recommended.

No supports needed.

Soldering: You will need a VNA to test your antenna.
Generally, the feedpoint is placed roughly 9 mm to 15 mm up from the bottom.

If you are making a tube antenna, always tune it while the antenna is in its enclosure, as the SWR is different compared to a bare antenna. If the resistance is too low, you need to move the feedpoint higher. If it is too high, bring it lower. It is usually a bit of trial and error.

Tagi