Jig for meshtastic EU_868 J-pole
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This model is made for easy and beginner-friendly way to make 869.525mhz tuned j-pole antenna. just bend, fit and cut.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 6
- Makes
- 0
- Views
- 78
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Portable Devices
- License
- Creative Commons — Attribution — Noncommercial
Tuned 869.525
just bend, fit, cut flush and solder.
made to be as beginner-friendly as possible.
PLA or PETG recommended.
No supports needed.
Soldering: You will need a VNA to test your antenna.
Generally, the feedpoint is placed roughly 9 mm to 15 mm up from the bottom.
If you are making a tube antenna, always tune it while the antenna is in its enclosure, as the SWR is different compared to a bare antenna. If the resistance is too low, you need to move the feedpoint higher. If it is too high, bring it lower. It is usually a bit of trial and error.
