1 / 11
Bike CO2 holder 16g & 25g (27,2mm/30,9mm/31,6mm/37mm) — zdjęcie 1
1 / 11

Bike CO2 holder 16g & 25g (27,2mm/30,9mm/31,6mm/37mm)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Bike CO2 mount to be used on a 36,76mm diameter tube, but has been tested on a 31mm seatpost (look the images) with no…

Ocena
5 / 5
Polubienia
73
Pobrania
233
Wydruki
1
Wyświetlenia
2579
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Sports
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Bike CO2 mount to be used on a 36,76mm diameter tube, but has been tested on a 31mm seatpost (look the images) with no problem.

UPDATE (22/01/2022): Added 25g CO2 holder for 31,6mm, 30,9mm and 27,2mm seat post. The measured 25g CO2 cartridges have a diameter of 25,5mm. Updated STL files of 16g CO2 cartridges for 31,6mm and 27,2mm seat posts to V2.

UPDATE (28/05/2020): Updated STL files, added .f3d file and also 27,2mm diameter CO2 holder.

NOTE 1: It has been designed for TOPEAK 16g cartridges with a diameter of 22,2mm, if yours has another diameter post a comment. If the diameter is another one it won't fit correctly.

NOTE 2: It can handle up to a 24mm wide strap. I tested with a 20mm wide and 25cm long strap (look at the photos).

If you need another bike tube diameter just post a comment, i have no problem to upload as many as you want.

The design has been tested and is very though, won't break easilly.

The thread is 3/8-24 UNF

Print Settings

  • Rafts are not totally necessary, but I had problems with the supports.
  • Try to use low resolution in order to have an accurate thread for the cartridges, i have tested with 0.16mm and it's fine.
  • 5 wall lines are recommended for better stiffness.

In CURA the "Layer view" should look like this:

Print Settings

Printer Brand:

Creality

Printer:

CR-10S

Rafts:

Yes

Supports:

Yes

Resolution:

0.16

Infill:

50%

Filament: eSUN PLA+ White How I Designed This ===================

I used a caliper and did some prototypes in Autodesk Fusion 360.

Category: Sport & Outdoors

Tagi