Mic Amp MAX9814 Enclosure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I needed an enclosure for an Adafruit MAX9814 Mic Amp so I made this one.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 25
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Share Alike
It's just a simple case, it should print easily in any material you like. No supports needed. I used a brim but that's just because I'm printing with ABS and it doesn't like sticking to my build plate.
The lid is a tight squeeze over the electret, I personally like it that way. You could use a negative volume cylinder in PrusaSlicer to make it a hair larger if you like, though I think that might encroach on the screw holes.
The lid pressure fits into the base relatively tight. For extra security, use two M2x6 screws. You'll need some good downward pressure on your screwdriver to get the M2 to bite into the screw stand-offs on the base.