Umarex HDS 68 Rib Riser
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The rib on the HDS is purely decorative as the barrel selector obscures it in use. This rises the rib by ~ 5mm.
- Ocena
- 5 / 5
- Polubienia
- 5
- Pobrania
- 82
- Wydruki
- 0
- Wyświetlenia
- 1719
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Sports
- Licencja
- Creative Commons — Attribution
The rib on the HDS is purely decorative as the barrel selector obscures it in use. This rises the rib by an additional ~5mm and adds a small "bead" front sight.
It comes in two parts, the barrel shroud/rib and the action shroud/rib.
The barrel shroud is attached by:
- Removing the screw under the muzzles.
- Sliding the shroud over the barrels
- Screwing the muzzle screw back in.
The action shroud is attached by
- Removing the two screws holding in the rear rip
- Clipping the new shroud over
- Using two new M3 bolds to hold in place.
Use the "Snug Fitting Barrel Band" to check the size before printing the two shrouds.
THIS IS WORK IN PROGRESS
NOTE: There is a roughly 4mm gap between the barrel and the action shrouds, as well as other minor issues.
NOTE: This is the shroud only, not the stock.
Designed in TinkerCad:
Snug fitting band: https://www.tinkercad.com/things/90in5zqflyO
Rib Riser (barrels): https://www.tinkercad.com/things/dxe9jeNi24v
Rib Riser (Body) https://www.tinkercad.com/things/l2uuNmjSFyd
Category: Sport & Outdoors