Umarex HDS 68 Rib Riser
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The rib on the HDS is purely decorative as the barrel selector obscures it in use. This rises the rib by ~ 5mm.
- Rating
- 5 / 5
- Likes
- 5
- Downloads
- 82
- Makes
- 0
- Views
- 1,719
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Sports
- License
- Creative Commons — Attribution
The rib on the HDS is purely decorative as the barrel selector obscures it in use. This rises the rib by an additional ~5mm and adds a small "bead" front sight.
It comes in two parts, the barrel shroud/rib and the action shroud/rib.
The barrel shroud is attached by:
- Removing the screw under the muzzles.
- Sliding the shroud over the barrels
- Screwing the muzzle screw back in.
The action shroud is attached by
- Removing the two screws holding in the rear rip
- Clipping the new shroud over
- Using two new M3 bolds to hold in place.
Use the "Snug Fitting Barrel Band" to check the size before printing the two shrouds.
THIS IS WORK IN PROGRESS
NOTE: There is a roughly 4mm gap between the barrel and the action shrouds, as well as other minor issues.
NOTE: This is the shroud only, not the stock.
Designed in TinkerCad:
Snug fitting band: https://www.tinkercad.com/things/90in5zqflyO
Rib Riser (barrels): https://www.tinkercad.com/things/dxe9jeNi24v
Rib Riser (Body) https://www.tinkercad.com/things/l2uuNmjSFyd
Category: Sport & Outdoors