1 / 8
Tineco A11 Extension Wand female replacement — zdjęcie 1
1 / 8

Tineco A11 Extension Wand female replacement

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Tineco A11/etc wand female piece that uses the 2 pin connector. Check description for latch details.

Ocena
0 / 5
Polubienia
0
Pobrania
1
Wydruki
0
Wyświetlenia
23
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a replacement piece that connects the extension wand to the vacuum. My vacuum model is A11 Master but I think it will work on any other vacuum that uses the same wand/piece. There is space for the 2 pin connector. Latch details below. I used PCTG, 0.6 nozzle, 0.24 layer height(0.3 probably would work too)

You will need the "rubber foot" piece from inside the tube/wand. Check the tube and twist/pull the broken off plastic it will come out. Ref.  "broken connector/rubber foot" image. 

Prep: If you need to, remove the broken off plastic from the original piece to make space for new. Remove the screw, take out the 2 pin connector first(without yanking the wires 😅), unclip both sides and pull the pins out. Then slide both pieces of the connector out.

Installation: Put rubber foot on the new piece, align so the foot notches onto the piece. Insert wires/pins through the channels in the replacement piece. Slide piece over the wand/tube/bulge.  Carefully insert pins into the 2 pin connector housing. Snap on the connector clip. Now you can seat the replacement piece fully if it isn't and align + screw the connector in with the same screw.


My original latch was broken but user Corey Ward has a model that fits perfectly and will work. You only need the original spring. 

Tagi