1 / 8
Tineco A11 Extension Wand female replacement — image 1
1 / 8

Tineco A11 Extension Wand female replacement

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Tineco A11/etc wand female piece that uses the 2 pin connector. Check description for latch details.

Rating
0 / 5
Likes
0
Downloads
1
Makes
0
Views
23
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

This is a replacement piece that connects the extension wand to the vacuum. My vacuum model is A11 Master but I think it will work on any other vacuum that uses the same wand/piece. There is space for the 2 pin connector. Latch details below. I used PCTG, 0.6 nozzle, 0.24 layer height(0.3 probably would work too)

You will need the "rubber foot" piece from inside the tube/wand. Check the tube and twist/pull the broken off plastic it will come out. Ref.  "broken connector/rubber foot" image. 

Prep: If you need to, remove the broken off plastic from the original piece to make space for new. Remove the screw, take out the 2 pin connector first(without yanking the wires 😅), unclip both sides and pull the pins out. Then slide both pieces of the connector out.

Installation: Put rubber foot on the new piece, align so the foot notches onto the piece. Insert wires/pins through the channels in the replacement piece. Slide piece over the wand/tube/bulge.  Carefully insert pins into the 2 pin connector housing. Snap on the connector clip. Now you can seat the replacement piece fully if it isn't and align + screw the connector in with the same screw.


My original latch was broken but user Corey Ward has a model that fits perfectly and will work. You only need the original spring. 

Tags