OnePlus 7T Pro kiosk frame for IKEA Skadis (wall dashboard)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Turns an old OnePlus 7T Pro into a built-in wall screen on a Skadis board. Anti-lift pegs, hidden USB-C plug.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 14
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial
We use an old OnePlus 7T Pro as a wall screen (Home Assistant in Fully Kiosk, mostly the CCTV view). This frame hangs it landscape on an IKEA Skadis pegboard so it looks built in rather than propped up.
How it fits
The phone sits face first in the frame. Lips over the flat short ends hold it front to back, and thin 1.5 mm lips on the long edges only cover the curved screen edge.
The spacer ring goes in behind the phone and presses on the flat part of its curved back, so it doesn't rattle.
Hollow sections at both ends: one hides a 90 degree USB-C plug with the cable running up, the other matches it so the frame looks balanced.
Hooks along the top go into the Skadis slots. Two pegs at the bottom drop into slots too and sit 0.5 mm under the top of their slot, so the frame can't be knocked off by an upward bump (the hooks need 4.5 mm of lift to come off).
To fit: hook the top on with the bottom tilted out, let it drop, then swing the bottom in. To remove: pull the bottom out about 6 mm, then lift.
There's no cut-out for the power button. I control screen on/off and restarts from Home Assistant, so I only take the frame off for the rare hard power-on.
Print settings
Printer: Elegoo Centauri Carbon 2, 0.4 mm nozzle
Layer height: 0.2 mm
Supports: none. The frame prints face down as supplied, the ring flat
Material: PLA (I used white)
Filament: about 54 g for the frame and ring
Time: about 1 h 30 min, both parts on one plate