INMP441 I2S Microphone Holder Mount Bracket - Snap-Fit
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Snap-fit remix of the INMP441 holder. The mic clicks in firmly and stays put. Easy to add to existing cases.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 52
- Wydruki
- 0
- Wyświetlenia
- 154
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Remix of INMP441 Digital Microphone Holder: thanks to the original creator for the base design!
The original holder is open on one side and meant to be mounted upside down against a surface, so the mic can't fall out. I wanted to build the holder into an existing case where the open side faces inwards, and there the mic would simply drop out. So I remixed it:
What's changed
Snap-fit retention tabs: two small triangular tabs inside the walls. Just press the INMP441 past them and it clicks into place. It holds the mic very firmly, so you don't need glue and it works in any orientation.
Second cable slot: the original has a wire slot on one side. I added one on the opposite side too, for more flexible cable routing.
Slim version: the soldered pin headers stay uncovered, which makes the holder slightly slimmer. This is the version I use in my own case.
Included files
Slim version (pin rows uncovered): tested and in use.
Covered version (pin rows enclosed, like the original): included for those who prefer it, but I haven't printed or tested it yet.