Shelf holder for Ikea Billy units (with 5mm fixing holes)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple and easy to print shelf holder for Billy bookcases with 5mm holes.
- Ocena
- 5 / 5
- Polubienia
- 3
- Pobrania
- 4
- Wydruki
- 1
- Wyświetlenia
- 20
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial
After being frustrated with the metal Ikea shelf pins I designed these. One issue I had was getting newer shelves for an older Billy bookcase, I am not sure if the newer ones have gone to a thinner pin but I believe they have, as the metal shelf inserts had a much thinner end, and just sat really badly in place (and fell out a lot).
This has been designed to print with the flat side down. I would suggest printing hot for max layer adhesion or even printing in smaller batches. Had some varied results, as printing batch seemed weaker than printing smaller numbers. Please do report back any results though.
I have printed them with 3 perimeters and 15% grid infill (I am lazy, i mostly leave it at that). I did a rough test and found the pin deformed a bit with 22kg of weight applied to it.
Please do use your own common sense, and check all the suggested weight limits for your shelf, and test them if you plan to really put in heavy weights. Printing these with tougher filaments may improve things but so far PLA feels fine (This is being used on the 40cm wide bookcase)
Suggest printing a test option to make sure it does fit your shelves first.