Radiator hook for IKEA BERGSHULT (no screws)

Radiator Cover Hooks for IKEA BERGSHULT

Simple 3D-printable radiator hooks for mounting an IKEA BERGSHULT wooden shelf/board above a radiator that requires no screws.

The hooks are designed to slide between the wall and the radiator. The BERGSHULT board then rests in the hooks, creating a simple radiator cover that hides the radiator while still allowing the radiator to function normally.

Dimensions: 80 × 30 × 2.5 mm (L × W × D)

You will need two hooks to support the board properly and keep it stable. Place one hook near each end of the radiator.

The included FreeCAD file and STL file are provided, so the design can easily be modified for a wooden board with a different depth or for other dimensions.

Files included

• STL – ready for 3D printing

• FreeCAD – editable source file

Designed as a simple, minimal solution using readily available IKEA BERGSHULT boards.

https://www.ikea.com/nl/nl/p/bergshult-ramshult-wandplank-walnootpatroon-zwart-s39491158/

Disclaimer: In my setup, the radiator is kept turned off. As a precaution, I recommend removing the hooks whenever the radiator is in use.

If you choose to use the hooks while the radiator is operating, make sure the radiator temperature stays below 50°C when using PLA.

If your radiator needs to operate at temperatures above 50°C, PETG should be used instead. PETG has better heat resistance than PLA, but actual performance depends on the filament, print settings, and load.

Always check the actual radiator temperature and make sure the printed hooks remain stable and do not deform during use. Use at your own risk.