Build Tray — Snapfit — Modular Organizer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A modular 3D printed snap-fit tray system remix designed for organization of small parts and components.
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 45
- Wydruki
- 0
- Wyświetlenia
- 254
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Description
These trays are a snap-fit remix version of Polymorphic's Build Trays. I love using Polymorphic's trays but needed a snap-fit version that allows me to stack trays high without worry of trays toppling over. The snap-fit trays allow me to stack trays and move them from one place to another with less chance of a tray falling off the stack.
Features
Snap-fit protrusions on the bottom of each tray
Snap-fit grooves on the inside of the trays to allow the protrusions to lock in to
Separation tolerance - the snap-fits were designed with approx. 0.4 - 0.8 mm of tolerance so the trays could be pulled apart slightly in order to pull or pry them apart. Pull or pry the trays apart at the corners using a fingernail or pry tool.
Print Settings
These are the settings used for the printed version shown in the images:
Material: PETG
Layer height: 0.2 mm
Infill: 15% - 25%
Infill pattern: Gyroid
Perimeters: 3 or more
Supports: Yes
Print Notes
If possible, paint the seams in your slicer away from the vertical wall portion of the snap-fit protrusions. I usually put the seam on the wall between the corner and snap-fit protrusion by painting the inside and outside wall between those two points. It is best for proper snapping if the seam is not on the inside or outside wall where the protrusion is located, put the seam to the left or right of the protrusion.
Any warping, even a small amount, might mess up the snap lock functionality so make sure your trays stay flat on the heat bed. I use Dimafix glue on smooth PEI sheets and have zero warping issues. I also have success without glue on satin and textured sheets for the smaller trays that print quicker. The build tray, 2x4, and 2x2 trays I use glue to be safe.
Updates
10/04/2026 - Minor change, uploaded new files, increased the snap-fit protrusion size slightly to give it a better snap feel.
10/04/2026 - I have snap-fit remixed Polymorphic's More Modules Build Trays. The snap-fit versions are located here:
10/04/2026 - I have created some lids that work with my snap-fit trays and Polymorphic's non snap-fit trays, located here: