Quad Lock Adapter Mount for Motorcycle GPS / Navigation
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Sturdy, vibration-friendly mount that connects a Quad Lock interface to your motorcycle navigation device
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 36
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a 3D-printable mount that lets you attach a motorcycle navigation device using a Quad Lock system. I designed it for my own bike, printed it on a Qidi Max 4, and it has worked well so far.
Features
Compact footprint: 42 × 42 mm flange, 25.4 mm total height
Four 8 mm screw pockets on a 30 mm grid for [M3 screws]
Reinforced base and flange for vibration and load
Prints with supports in the orientation of the STL (flange down to the plate, ring opening facing up)
Designed for a strong, UV- and heat-resistant print in ASA
Print settings (what I used)
Printer: Qidi Max 4
Material: ASA (recommended). PLA for test fit recommended.
Layer height: 0.2 mm
Walls: 4–5
Top/bottom layers: 5–6
Infill: 40–50 % (Gyroid or Cubic)
Nozzle 0,4mm; ~250–260 °C
bed ~100 °C, heated chamber
Part cooling low (0–30 %) for better layer adhesion
tree supports (small trees) under the flange overhang, everything else prints without support
Dry your filament before printing
Disclaimer
Use at your own risk. This is a hobby design and has not been certified or tested to any safety standard. I am not affiliated with Quad Lock. Quad Lock is a trademark of its respective owner.