Silica Gel Scoop for Desiccant Boxes
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A small scoop that pours silica beads into desiccant boxes without jamming or scattering.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 31
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Spoons scatter the beads and funnels jam. This scoop has an 18 mm spout that's open at the top, so the beads can't wedge and block it. It holds about 36 ml to the rim.
It's 39 mm wide, so it dips into any box with an opening over about 4 cm to level the beads. I use it for two:
- famichu's desiccant cases for the Sovol SH02 dryer, about one scoop per case: https://www.printables.com/model/1014919
- the silica container in Pyry's IKEA 365+ drybox: https://www.printables.com/model/866936
Print settings: PLA, 0.2 mm, no supports, flat as it is in the file. About 23 min and 11 g.
The OpenSCAD source is included.