Windowhook
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A short overengineered hook to keep my office window open.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 23
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a small overengineered hook to attach my open window to my Kallax shelf standing behind with a strip of double-sided tape.
For proper storage the hook is stored away and held in place with some magnets. To attach it to the window, just pull it out and rotate it by 180 degrees. In the end position it is again secured by a pair of magnets.
Print Instructions:
4 perimeters
15% Infill - Gyroid
Material: I used PLA, but every material of your choosing should fit fine.
Materials used:
1x M3x40 machine screw
1x M3 heated insert
4x 8x3 round magnets
Assembly:
Put the heated insert into the front part of the hook (longer piece) and put the magnets in their holes. Please watch the polarities. After that insert the two hook parts in the housing. Be aware the two notches should face in the same direction (see picture) and screw them together. Done, just attach it with double sided tape to the place you need it.