1 / 9
Savage 110 Stock - Front Bag Rider | Rear Bag Rider | Cheek Riser - Hogue Overmolded — zdjęcie 1
1 / 9

Savage 110 Stock - Front Bag Rider | Rear Bag Rider | Cheek Riser - Hogue Overmolded

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Front Bag Rider, Rear Bag Rider, and Cheek Riser for the Savage 110 Hogue Overmold Stock

Ocena
0 / 5
Polubienia
0
Pobrania
11
Wydruki
0
Wyświetlenia
81
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial

Upgrades to the Savage 110 Hogue Overmolded Stock

Front Bag Rider:
Angled precisely to keep the barrel level. Remove the front swivel stud. Secure the front rider with a 10-32x3/4" or 5/8" socket head and flat washer. Change direction of print to length-wise parallel with direction of travel for less friction. Tree supports might be needed for the screw head relief.

Fits Protektor Model #3 Wide Owl Ear Front bag. With a stable fore-end, you may notice more flex/twist in the stock. Consider stiffening the fore-end for better stability.

Rear Bag Rider:
Leave the rear swivel stud in place. Press on and secure with 6-32x1" socket head screw, washer, and nut. It was measured off my rifle, so your rear stud may have a different depth.

Cheek Riser:
Remove the rear buttpad using a Phillips #2 screwdriver (lube the screwdriver shank to avoid damage to buttpad holes). Place cheek riser with buttpad spacer on the stock and re-install the buttpad. Secure the front of the cheek riser with hockey tape or any tape of your choice.

Raises the cheek weld ~5/8". Works well with the Arken EP-5 5-25 and 0.97" low rings, to give you a general idea. It is cut far enough back to gives clearance for bolt removal in the short action; I unsure if it has enough clearance for a standard action.

Tagi