Savage 110 Stock - Front Bag Rider | Rear Bag Rider | Cheek Riser - Hogue Overmolded
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Front Bag Rider, Rear Bag Rider, and Cheek Riser for the Savage 110 Hogue Overmold Stock
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 12
- Makes
- 0
- Views
- 102
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial
Upgrades to the Savage 110 Hogue Overmolded Stock
Front Bag Rider:
Angled precisely to keep the barrel level. Remove the front swivel stud. Secure the front rider with a 10-32x3/4" or 5/8" socket head and flat washer. Change direction of print to length-wise parallel with direction of travel for less friction. Tree supports might be needed for the screw head relief.
Fits Protektor Model #3 Wide Owl Ear Front bag. With a stable fore-end, you may notice more flex/twist in the stock. Consider stiffening the fore-end for better stability.
Rear Bag Rider:
Leave the rear swivel stud in place. Press on and secure with 6-32x1" socket head screw, washer, and nut. It was measured off my rifle, so your rear stud may have a different depth.
Cheek Riser:
Remove the rear buttpad using a Phillips #2 screwdriver (lube the screwdriver shank to avoid damage to buttpad holes). Place cheek riser with buttpad spacer on the stock and re-install the buttpad. Secure the front of the cheek riser with hockey tape or any tape of your choice.
Raises the cheek weld ~5/8". Works well with the Arken EP-5 5-25 and 0.97" low rings, to give you a general idea. It is cut far enough back to gives clearance for bolt removal in the short action; I unsure if it has enough clearance for a standard action.
