1 / 5
Dual 120mm Fan Shroud for Zotac Trinity OC RTX 3090 — zdjęcie 1
1 / 5

Dual 120mm Fan Shroud for Zotac Trinity OC RTX 3090

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Custom fan shroud for mounting 2x120mm fans onto the Zotac Trinity OC version of the RTX 3090.

Ocena
0 / 5
Polubienia
2
Pobrania
9
Wydruki
0
Wyświetlenia
129
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Share Alike

The stock fan shroud for the Zotac RTX 3090 sounds like a jet engine at full load, so I designed a shroud to fit two Noctua NF-A12x25s onto it instead of the three stock 80mm fans. Now runs basically silent at full load. Mounts using the 6 M2 screws used to mount the stock shroud to the heatsink, no tab bending or other modification needed. You may need to remove the heatsink from the card to be able to unplug the original fan headers. 

With 25mm thick fans, the total assembly is about 3.5 slots wide. With 15mm thick fans it's about 2.75-3 slots wide depending on the height of the bolt heads you use. If you mount this horizontally like in a standard case, definitely use a GPU support. 

Required hardware:

  • Zotac RTX 3090

  • 2 120mm fans

  • 2x M2x14 or longer bolts

  • 2x M2 hex nuts

  • 8x M4 hex nuts

  • 1-2x GPU fan header to standard 4 pin header adapter (1x if you use a Y splitter like I did, 2x if you don't)

  • For 25mm fans, 8x M4x30mm bolts

  • For 15mm fans, 8x M4x20mm bolts

The design is split into two halves to be printable on a Prusa Mk4S sized bed, and the two halves are attached with aforementioned M2 bolts. The original Solidworks and STEP files are provided with an intersect op for splitting so you can print it as one if you have a big enough printer. Sorry in advance for my horribly messy sketches, this was kind of done in a rush.

Tagi