UniFi U7 In-Wall – Wall Mount Bracket (90° and 70° versions)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wall mount for UniFi U7 In-Wall AP: original panel, side flange with 3 M6 holes, print-ready. 90° and 70° versions.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 34
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Public Domain
What it's for
A wall bracket that holds a Ubiquiti UniFi U7 In-Wall access point on a vertical surface, with no in-wall electrical box needed. The AP sticks out from the wall like a flag rather than lying flat against it.
Main features
Mounting panel : 3 AP mounting holes and stiffening ribs, so the U7 In-Wall fits correctly.
Side wall flange: 35 × 94 mm, 5 mm thick, on the left edge of the panel as seen from the AP side.
3 × Ø6.6 mm through holes for M6 screws (ISO 273 medium clearance), in a vertical line 35 mm apart.
Reinforcing fillet (8 × 8 mm) running the full height between flange and panel, for extra stiffness.
Two versions:
90°: the panel is perpendicular to the wall.
70°: the panel is angled 20° away from the wall. Screw access is tighter, so use a short or L-shaped hex key.
Print-ready orientation: the wall-contact face lies flat on the bed. Footprint is about 35 × 94 mm, height about 90 mm.
Print notes
No other supports needed: the panel prints upright, or at a 20° lean in the 70° version.
Opening top edge: the top edge of the cable opening is an approx. 35 mm bridge. Most printers handle it without supports.
Rib undersides: they overhang about 5 mm, so "support on build plate only" is recommended there.