1 / 2
UniFi U7 In-Wall – Wall Mount Bracket (90° and 70° versions) — image 1
1 / 2

UniFi U7 In-Wall – Wall Mount Bracket (90° and 70° versions)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Wall mount for UniFi U7 In-Wall AP: original panel, side flange with 3 M6 holes, print-ready. 90° and 70° versions.

Rating
0 / 5
Likes
1
Downloads
2
Makes
0
Views
35
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Public Domain

What it's for
A wall bracket that holds a Ubiquiti UniFi U7 In-Wall access point on a vertical surface, with no in-wall electrical box needed. The AP sticks out from the wall like a flag rather than lying flat against it.

Main features

  • Mounting panel : 3 AP mounting holes and stiffening ribs, so the U7 In-Wall fits correctly.

  • Side wall flange: 35 × 94 mm, 5 mm thick, on the left edge of the panel as seen from the AP side.

  • 3 × Ø6.6 mm through holes for M6 screws (ISO 273 medium clearance), in a vertical line 35 mm apart.

  • Reinforcing fillet (8 × 8 mm) running the full height between flange and panel, for extra stiffness.

  • Two versions:

    • 90°: the panel is perpendicular to the wall.

    • 70°: the panel is angled 20° away from the wall. Screw access is tighter, so use a short or L-shaped hex key.

  • Print-ready orientation: the wall-contact face lies flat on the bed. Footprint is about 35 × 94 mm, height about 90 mm.

Print notes

  • No other supports needed: the panel prints upright, or at a 20° lean in the 70° version.

  • Opening top edge: the top edge of the cable opening is an approx. 35 mm bridge. Most printers handle it without supports.

  • Rib undersides: they overhang about 5 mm, so "support on build plate only" is recommended there.

Tags