Quantum Band V1 – Articulated Print-in-Place Bracelet | PrintVision
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Reversible articulated bracelet with an integrated snap clasp. Four lengths; prints flat with no supports.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 95
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Fashion Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
PRINTVISION QUANTUM BAND V1 – Reversible Print-in-Place Bracelet
One bracelet. Two different looks.
The PRINTVISION QUANTUM BAND V1 is a narrow, articulated bracelet with a futuristic mechanical style. Wear either side facing outward:
Diagonal side: alternating angled armor panels for a distinctive sci-fi appearance.
Fully Print-in-Place
All articulated joints print together with integrated captive axles. No separate pins to insert, no assembly of individual links and no additional hardware.
After printing, gently free the joints, wrap the bracelet around your wrist and close the integrated snap clasp.
Integrated Snap Clasp
Simply press the ends together to close and pull them apart to open. Two reinforced snap features hold the ends together without a separate key, screws or magnets.
Features
Reversible design — wearable on both sides.
Flexible, independently articulated links.
Approximately 15 mm wide and 4.8 mm thick.
Subtle PrintVision branding.
Looks complete in a single color.
Four available bracelet lengths: 182, 192, 202 and 212 mm.
The listed sizes are nominal bracelet lengths, not wrist circumferences. Allow some extra room for a comfortable fit.
Printing
Material: PLA / PLA+
Nozzle: 0.4 mm
Layer height: 0.20 mm
Orientation: flat, as supplied
Supports: none
Avoid scaling the complete model, as this also changes the joint clearances and snap fit. Choose the appropriate length instead.
The articulated joints and snap clasp have been successfully tested on my print. Results may vary with filament and printer calibration. Small hinge and clasp test files are included so you can check the fit before printing the complete bracelet.
Designed by PrintVision.