Cable plug for 40 mm corrugated conduit – 6x 6 mm² solar cable (snap-in slots)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Plug for Ø40 corrugated conduit that seals 6 solar cables (6 mm²). Side slots let you clip the cables in without pulling
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 27
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
What it is
A plug for a 40 mm red corrugated conduit (OD 40, ID 32) where six 6 mm² solar cables (H1Z2Z2-K, ~6.5 mm OD) enter the conduit. It closes the open conduit end as tightly as possible so dirt, water and insects stay out.
Why the slots
The cables where already in place when I wanted to close the conduit. Every cable hole has a slot to the outside that is 1.5 mm narrower than the cable. Push each cable sideways through its slot, it snaps into the hole and is clamped. Then slide the plug along the cables into the conduit until the collar seats on the conduit mouth. No need to disconnect anything.
Design
- Core Ø32 x 30 mm goes into the conduit, collar Ø40 x 3 mm seats on the conduit edge.
- 4 mm fillet between core and collar so the conduit mouth centers on the plug and presses tight.
- 8 mm guide section above the collar.
- Six Ø6.8 mm cable holes (6.6 + 0.2 clearance) on a 19.6 mm pitch circle, funnel chamfer on both ends.
- Slot width 5.1 mm with a lead-in chamfer at the outer edge.
Other cables or conduits
The OpenSCAD source is included. All dimensions are named variables at the top of the file: core diameter, collar diameter, cable diameters (a list, one per hole, so mixed cables work), slot clamp amount and pitch circle radius. Change, press F6, export.
Print settings (tested)
- Printer: Prusa MK4S, 0.4 mm nozzle
- Material: ASA
- Orientation: tip (core end) on the bed, cable axis vertical. The fillet under the collar then prints as a gentle overhang without support.
- No supports, 0.2 mm layers, 3 perimeters, 15 % infill.
Measure first
Solar cable OD varies between brands (6.4–6.8 mm). Measure one cable with calipers and set kabel_d in the .scad if yours is different.