Tag-Connect TC2030-CLIP handle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Small ribbed handle for the Tag-Connect TC2030-CLIP board, with string holes at both ends. Prints without supports.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 23
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
A handle for the Tag-Connect TC2030-CLIP retaining board. The clip is glued into a pocket flush with the top face, with its socket barrels in wells underneath. The wells flare at the top to make room for the solder on hand-soldered barrels.
Grip ribs run along the long sides, and each end has a hole for a string or lanyard.
Print it pocket up; it needs no supports.
The pocket is 1.5 mm deep, sized for the clip board as I measured it. Tag-Connect's drawing gives 0.914 mm, so measure your board and change clip_t in the .scad if it differs.