Tag-Connect TC2030-CLIP handle
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Small ribbed handle for the Tag-Connect TC2030-CLIP board, with string holes at both ends. Prints without supports.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 1
- Makes
- 0
- Views
- 23
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
A handle for the Tag-Connect TC2030-CLIP retaining board. The clip is glued into a pocket flush with the top face, with its socket barrels in wells underneath. The wells flare at the top to make room for the solder on hand-soldered barrels.
Grip ribs run along the long sides, and each end has a hole for a string or lanyard.
Print it pocket up; it needs no supports.
The pocket is 1.5 mm deep, sized for the clip board as I measured it. Tag-Connect's drawing gives 0.914 mm, so measure your board and change clip_t in the .scad if it differs.