Pergola Hanging Bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Parametric bracket designed to clip onto the center beam of popular louvered outdoor pergolas.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 15
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Share Alike
This is a parametric bracket designed to hang a light (from its cord) from the center beam of my pergola.
The dimensions for my particular pergola center beam are:
134.5mm Wide, 27mm Tall with ~1.7mm Thick Metal
and My Light Kit's cord was 7mm wide and 4mmm thick.
However the Dimensions are settable in the FreeCAD model's Data Sheet. If you edit the parameters and then recompute the final model, it should update "within" reason.
Due to the nature of the cord clips, you do need a small amount of support, and you have to remove that support after the fact.
I used ~40% Gyroid infill and 3 perimeters to make sure the hooks were "well integrated" into the main bracket's plastic. As often for non appearance stuff I did .3mm Draft High Speed layers. Printed in Black PLA (was it is not exposed to sun, though it is outside. If you leave your pergola open more often then not you might want to use PETg instead.