VESA 75x75 to Tripod Head Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
L-bracket that mounts any VESA 75 display or device onto a standard tripod head with a 3/8"-16 bolt.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 17
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A sturdy L-bracket that lets you put anything with a VESA 75 mount (small monitors, field displays, TVs, tablet holders) on a standard tripod head.
Hardware:
Tripod side: one 3/8"-16 hex bolt. The head sits in the 9/16" hex pocket on the underside of the base so it can't spin, and the 10 mm hole gives clearance for the shank.
VESA side: four screws on the 75 x 75 mm pattern. The 6.5 mm holes clear M6 and will also pass the M4 screws most VESA 75 devices use.
Dimensions: about 100 x 100 x 110 mm, with a 10 mm thick mounting plate and a curved gusset between the plate and base for stiffness.
Designed in Onshape.
Printing (no supports): stand the part on its outer corner, the edge where the base meets the back of the VESA plate, and rotate it about 45 degrees so both the plate and the base rise at an angle. Nothing overhangs, and the layers run across the bend instead of along it, so the joint is much stronger than printing it flat. Add a brim for bed adhesion, since the contact patch is small. The slicer screenshots show the orientation.
My settings: PETG, 4 walls, 35% infill, printed at 45 degrees as above. I chose PETG because the mount sits behind a monitor where it can get warm, and it's holding a camera; PLA can slowly creep under load when warm.