Raspberry Pi 5 + X1206 UPS CASE
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Screwless two-part snap case for a Raspberry Pi 5 stacked on a Geekworm X1206 4-cell 21700 UPS.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 49
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Openings
Pi 5: all four USB ports, Ethernet, USB-C, both micro HDMI, the microSD card, and the power button and status LED.
X1206: both USB-A outputs, the DC jack, the USB-C charging port, the side power button, and the battery and status LEDs.
A 12.2 mm hole in the roof for a panel-mount power button (wire it to the X1206's PSW header), plus vents and a small cable exit.
Assembly
Screw the Pi onto the X1206 as normal and fit the cells.
Drop the stack into the tray. The gold-hole pegs locate the board.
Clip the fan into the shell's bracket.
Press the shell down until it clicks.
Fits
Geekworm X1206 V2.0 (same layout as V1.1) with four flat-top 21700 cells
Raspberry Pi 5
Outside size: 113.6 × 90.6 × 58 mm.
Notes
The X1206 board heights came from photos, not calipers, so tolerances are about ±0.5 mm. Clearance is built in, but let me know in the comments if something rubs.
The STEP file has both parts in their assembled position if you want to remix it.
Print settings
Material: PETG (heat near a Pi and Li-ion cells, and the snaps need some flex). Don't use PLA if the case will sit somewhere enclosed or warm.
Layer height: 0.2 mm
Walls: 3
Infill: 20% gyroid
Supports: none
Orientation: the tray prints as is; the shell file is already flipped roof-down.
Printer used: Ender 3 S1 Pro
