1 / 11
Raspberry Pi 5 + X1206 UPS CASE — image 1
1 / 11

Raspberry Pi 5 + X1206 UPS CASE

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Screwless two-part snap case for a Raspberry Pi 5 stacked on a Geekworm X1206 4-cell 21700 UPS.

Rating
0 / 5
Likes
0
Downloads
7
Makes
0
Views
49
Reviews
0

Updated at source:

Model information

Category
Computers
License
Creative Commons — Attribution — Noncommercial — Share Alike

Openings

  • Pi 5: all four USB ports, Ethernet, USB-C, both micro HDMI, the microSD card, and the power button and status LED.

  • X1206: both USB-A outputs, the DC jack, the USB-C charging port, the side power button, and the battery and status LEDs.

  • A 12.2 mm hole in the roof for a panel-mount power button (wire it to the X1206's PSW header), plus vents and a small cable exit.

Assembly

  1. Screw the Pi onto the X1206 as normal and fit the cells.

  2. Drop the stack into the tray. The gold-hole pegs locate the board.

  3. Clip the fan into the shell's bracket.

  4. Press the shell down until it clicks.

Fits

  • Geekworm X1206 V2.0 (same layout as V1.1) with four flat-top 21700 cells

  • Raspberry Pi 5

Outside size: 113.6 × 90.6 × 58 mm.

Notes

  • The X1206 board heights came from photos, not calipers, so tolerances are about ±0.5 mm. Clearance is built in, but let me know in the comments if something rubs.

  • The STEP file has both parts in their assembled position if you want to remix it.

Print settings

  • Material: PETG (heat near a Pi and Li-ion cells, and the snaps need some flex). Don't use PLA if the case will sit somewhere enclosed or warm.

  • Layer height: 0.2 mm

  • Walls: 3

  • Infill: 20% gyroid

  • Supports: none

  • Orientation: the tray prints as is; the shell file is already flipped roof-down.

  • Printer used: Ender 3 S1 Pro

Tags