Modular LED Letter Sign with Magnetic Pogo Connectors (guide)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Swappable LED letters with a 12 V strip inside that snap onto a powered rail via magnetic pogo connectors.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 4
- Wydruki
- 1
- Wyświetlenia
- 51
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Public Domain
Modular LED Letter Sign
This is more of a guide for building your own sign than a ready-to-print model. Your text, letter count and spacing will differ, so use the files and the Onshape document as a starting point and adapt them.
Individual 3D-printed letters with an LED strip inside that snap magnetically onto a powered rail. You can rearrange or swap letters without tools. The rail holds up to 15 letters. The caps are printed from glow-in-the-dark PLA, so the sign keeps glowing after you switch it off.
Letters
The letters were generated with Hollow Interlocking LED 3D Letters and Numbers on MakerWorld. All credit for the letter design goes to its author.
Rail
I designed the bottom rail in Onshape: Onshape – LED sign rail
I imported the generated letters into Onshape and placed them along the rail to lay out the text and check the spacing. To make the openings for the pogo connectors, I subtracted the included connector model from the letters and the rail, which gives a perfect fit without any measuring. The rail is split into several segments so it fits on the print bed. The first segment holds the power input, and the wiring runs inside the rail. You can copy the document and adjust the length and the connector positions for your own text.
Materials
12 V white LED strip, 60 LED/m, 10 mm, IP65 (10 cm per letter)
2-pin magnetic pogo connector, 2.8 mm pitch (1 per letter)
2×0.35 mm² flat cable
Panel-mount DC jack 5.5/2.1 mm
12 V / 1.5 A power adapter
Heat shrink tubing
Printing
Caps: glow-in-the-dark PLA
Bodies and rail: Prusament PLA Galaxy Black
Assembly
Generate your letters on MakerWorld and place them on the rail in Onshape.
Cut the connector openings by subtracting the included connector model.
Cut the LED strip at the 5 cm marks and stick it inside the letter. Each letter takes 10 cm.
Solder the strip to the pogo connector and insulate the joints with heat shrink.
Fit the connector into the bottom of the letter and snap on the cap.
Print the rail segments, join them and wire all connectors in parallel to the DC jack.
Check polarity with a multimeter and plug in the adapter.
Each letter draws about 70 mA, so 15 letters draw about 1.05 A in total.
Designed & built by Ing. TULák
GitHub: https://github.com/davidvancl
If you build your own sign, please share a Make – I’d love to see what yours says! Questions, ideas or improvements are welcome in the comments.
Thanks for downloading and may your letters always shine!