1 / 4
Shrimp Feeding Tube with Dish for Rimless Tanks — zdjęcie 1
1 / 4

Shrimp Feeding Tube with Dish for Rimless Tanks

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Feeding tube that hangs on the glass and drops food into a dish just above the substrate.

Ocena
0 / 5
Polubienia
1
Pobrania
0
Wydruki
0
Wyświetlenia
14
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Pets
Licencja
Standard Digital File License

A square feeding tube that hangs on the glass and ends in a small dish 5 mm above the substrate, so sinking food lands in the dish instead of the gravel.

Drop food down the tube and it lands in a dish just above the substrate, where shrimp and snails can reach it and leftovers are easy to take out. The tube hangs on the top edge of the glass by a clip; the inside is 12 mm square, wide enough for 5 mm food. It prints lying on its side with no supports.

What it fits

  • Rimless glass 4, 6 or 8 mm thick (bare top edge; no plastic frame).

  • Drop from the top of the glass to the substrate: 150, 200 or 250 mm (one file each).

  • The clip's outer leg runs 12 mm down the outside of the glass: that strip must be bare glass.

What you need

  • PETG filament.

Print settings

  • Material: PETG

  • Nozzle: 0.4 mm

  • Layer height: 0.2 mm

  • Walls: enough to fill the walls

  • Infill: 100% — air sealed inside can make it lighter than water, and it only rests on the glass by its weight

  • Supports: None (the far side wall bridges 26 mm; leave bridge detection on)

  • Orientation: On its side, as in the file.

  • Bed: 150 and 200 mm drops fit 220 mm beds; the 250 mm drop (248 mm long) needs a 256 mm bed. On a 180 mm bed the 150 mm drop fits on the diagonal.

Files

  • shrimp-feeding-tube_drop{150|200|250}_glass{4|6|8}mm.stl — nine files: pick your drop and your glass

Fitting

  • Measure from the top edge of the glass down to the substrate where the tube will hang; pick the nearest drop below it.

  • Slide the clip over the glass edge; it should go on with a light push and sit flat.

Limits

  • A lid resting on the glass will sit on the 3 mm plate of the clip.

  • Food that sticks to the walls stays there; a knock can lift the dish.

How it was checked

Checked by simulation, not printed by us yet: the geometry is checked for fit (clearances), wall thickness against a 0.4 mm nozzle, bed size and overhangs. Loads are not simulated. If it does not fit, a comment with your measurements helps.

Safety

  • Use PETG for parts that stay under water.

A parametric version of this part is on mislastudio.com: https://mislastudio.com/m/tubo_alimentador?utm_source=printables&utm_medium=free_model&utm_campaign=tubo-alimentador

Designed by Misla, a small studio of engineered 3D-printable parts: https://mislastudio.com/?utm_source=printables&utm_medium=free_model&utm_campaign=tubo-alimentador

Tagi